I removed and dismantled the setback restraining bar behind my back seat to get it cleaned up and rechromed. When I removed the ends there were rubber strips that were apparently put there during assembly. Can anybody tell me whether these should be replaced when I reassemble everything? If...
Thought I'd add my experience since I've got the same Dr. Diff setup as the OP - 13" front / 11.7" rear with 15/16" MC. When I first bench bled the MC there was absolutely no fluid movement out of the rear port until nearly half the piston stroke - the front port had fluid movement immediately...
Hi! Thanks for taking a look. That's a good question, and I don't know the answer. It is from Jegs - PN 555-104920 - and they should know. The length is greater than what I stated - there's about 18' of it.
Auto Custom Carpets Item #1110 - Passenger area 4 speed without console strip, loop, black. Ordered in 2014 but not used. Box was opened, but carpet has never been removed. Lake Tapps, WA 98391. $150.
Complete set of wiring harnesses from Year1 purchased 4/16 and not used. Included is HU270AM / Engine & Forward Light, RL13 / Rear Lamp, and HU303A / Dash Harness. Front & rear harness bags are sealed, dash harness bag has been opened. Total price for these harnesses on the Year1 site is over...
This is an 800 CFM 9801S with the strip kit I've owned since new. It has been sitting a long time and will need to be gone through and thoroughly cleaned. I am located in the Seattle Tacoma area - zip is 98391. I am asking $100.
I have two sets of small block fenderwell headers that fit '64-66 A-bodies. One set is Cyclone, purchased originally in '74. These were rebuilt by a local shop (Stan's Headers, Auburn, WA) and Jet-Hot coated about 20 years ago. They never got used after the rework, and were never even removed...