This is a nice set of Edelbrock small block valve covers. They were made by Holley-M/T I'm guessing in the 70's. The only other one I've seen is a black pair that I also own. You can clean them up and paint or powdercoat them or use them as is for a driver quality engine bay. Looking to get $200...
This is a 4' garden/park bench styled like a vintage Dodge truck bed. I made this during the Corona era but realize that I really don't have a place for it. The red is a wood dye and coated with urathane. The seat slats are red oak. The hardware is all polished stainless steel. The ends are...
Looking again, the upper tabs on the 72 are offset where mine was straight across. The picture in my first post is wrong so I removed it. These are my mounting holes.
3769052 is correct but the one you listed from Ebay has different mounting locations. The pictures aren't the same as mine. It has to be for an A body.
I'm looking for the charcoal canister bracket for a 74 Dart. I think 72-76 are the same. Any condition is fine, the cheaper the better. If anyone is going to the Garlits show and can bring one that would be great. I'll be there Saturday looking for one. Thanks FABO.
These are a pair of aftermarket hinge covers. They are more of a hard plastic than the OEM ones which are more flexible. They may have been painted before because I see a run or two. I will be leaving for Carlisle on Thursday and will be there Saturday and will bring them with me. $20.00 plus...