Recent content by wjajr

I run a Clifford shorty 4v intake and headers on a slant 6. When I got the car I soon discovered living on the coast and temperatures dropped below 55* on a humid day drive-ability was bad, would not idle, and drank fuel like the tank had a hole in it caused by carburetor icing. I used some...

I have often seen lock washers placed between bolt head and a flat washer which makes no sense what so ever. The point of a lock washer is to retard a bolt from backing off by biting into both the head of the bolt which is movable and a solid immovable surface such as a block or such. Use the...

OK thought so, PC coming soon

I can't seem to locate a PM button to click. It has been a while since using this site. Would I click on start a conversation after clicking on your name?

I can't seem to locate the PM click button. Do I click on start a conversation?

Yes Dana, that's the plug. I'm missing both the plastic housing and the female metal connectors housed within. The plug and a several inches of pig tail wire to splice to would fix me up.

The left hand gauge cluster circuit board five pin female connector. 1967-71 are the same part

Jim Lusk: That is a good option for non-original stock appearing fix. I am still using my top switch in my unrestored 72,000 mi 1982 Mark Cross LeBaron ordered Jan of '82. LOL That is why I made a few behind dash circuit reconfigurations keeping that stock look and function of the 67 Dart.

Just an idea: I installed relays to relive the 30 amp load from the top motor dash switch in 2008. Those switches are hard to find, appear to be under sized, and are getting old. Now the dash switch handles very low amperage as a trigger for two relays that do the heavy work. I utilized...

Three sunny days in the low 90's with windows rolled up will help relax that rubber back into shape.

This is the brace that bolts at wheel opening flange and to upper inner fender. I need both sides; the one shown below is from right side and is missing one end. PM me if you can help.

I need two seat medallions to install in front bucket seat backs, and have not seen any reproductions of this item. Whoever installed new seat covers on my front seats many moons ago never transferred the metal medallions.

I think AMD has two 1/4's, one is full replacement that intersects part way up C pillar and trunk deck filler section at factory seam, and one that is cut just below top crease covering only vertical portion of quarter.

Steer n Gear in Ohio has them as well.

I have to go with 67dart270 on all the electrical tests, particularly alternator output, and voltage regulator condition. That said, I suspect your choke is also out of adjustment. After a full night cool down, before starting engine, remove air cleaner, and crack open throttle by hand about...