zigs replied to the thread Glove insert.

I lke my own

zigs replied to the thread Glove insert.

Resin might work but you have to be careful in not adding too much bulk

zigs posted a new thread.

Glove insert

Thought I would pass this along. Since no one is making plastic glove box inserts any more I thought I would try this. I bought a cheap...

Forum: Mopar Interiors

zigs replied to the thread Motor mount question.

I know found that out . I think B/E

zigs replied to the thread Motor mount question.

If I start having trouble Ill look into them

zigs replied to the thread Motor mount question.

Have valve covers out getting powder coated. Ill post pic when I get them.

zigs replied to the thread Motor mount question.

Not making my own mounts . Pass side ok reworking driver side

zigs replied to the thread Motor mount question.

I never thought of that that would have been a possiblity

zigs replied to the thread Motor mount question.

I dont plan on doing any hard launching but then again I get a brain fart once in a while. I think Ill box the biscuit. But still...

zigs replied to the thread Motor mount question.

Not really already mocked it up. It will be close. I would preffer 340 mount but have had no luck. Dont want to pay $150 for a kit when...

zigs replied to the thread Motor mount question.

Yes , thought about that also. How about boxing the biscuit like a steel buscuit

zigs attached a file to the thread Motor mount question.

This is how it would be mounted. I can also gusset for strength[ATTACH][ATTACH]

zigs replied to the thread Motor mount question.

LOL. The top picture is the redo. I just thought there was a reason to mount to outside of engine mount. Maybe stress reasons ?

zigs posted a new thread.

Motor mount question

Motor mount question. I thought I had 318 motor mounts was going to use them on a 72 340. Driver side mounted with spacer but bisket...

Forum: Mopar General Discussions

zigs replied to the thread [WANTED] 340 motor mount.

All I saw were biskets no mounts