8.75, 741 pinion seal replacement.

So Its time to replace my seal, its been leaking a few drips each day on the garage floor. Just gotta find a really big socket now.

I checked the fluid, its still fine, but its got some pressure in there. Wondering if the vent is plugged. How do you clean it? Does that little cap pop off?

Going to do the axle seals too, as one is leaking a bit. While I have the axle out I may as well adjust the back lash.
How do you do this? I googled it, but all I get is the same axle info, on all the sites, but none really explain how to set the back lash.

Sigh, seems like I have taken my wheels off and on 100 times in a week dealing with that stuck wheel cylinder too.