Front end rollers

C130 Chief said

I see no weld details, but assume a 1/8" fillet weld all around (typ).

Also, a horizontal tie-bar (could be bolted in) would make the whole system much stronger for those who have rough or uneven work surfaces.

Click to expand...

i left the weld symbols off for two resons, Honestly, one, im not very knowledgeable about weld symbols, and two i figured the welder would now what would work the best. i believe the 1/8" fillet weld would be fine....


the mountes are desinged to roll the car WITHOUT the k-member. mine is out so i didn't even think about it interferring with the rollers if it was installed. i will go do some looking today and see it is going to be a problem and adjust the drawings accordingly.

thanks for the input guys it is a great help to have more than one mind when working on something. :-D