Stroked Big Block

Here is a list of all the parts that I can remember
Built for 2500-6500RPMs
1976 400 block, Hot tanked, Bored for .033" Pistons, Plate honed for plasma moly rings, blocked decked to ensure flatness
total seal file fitted plasma moly part# CR9190-125
440source Aluminum Heads (stock out of the box)
Keith Black 500 cu in stroker forged pistons
Hughes Performance 3 bot Roller Cam (with 1.5 rockers, it is .513 lift on intake, .533 on exhaust)
Crower Roller lifters (lightly used)
Cloyes hex-a-just double roller timing set, with cloyes cam button
440source neutral balance flexplate
3/8" chrome moly ball/socket pushrods (used)
Milidon oil pan part# 31010
Milidon 1/2" oil pickup part# 18330 (engine block drilled and tapped for same at machine shop)
Mellinf HV oil pump
Clevite P-series main bears part# MS876P (scraped at machine shop for tapered crank)
Federal Mogul CH Series rod bearing part# Z87135CH
Dura-Bond caoted cam bearings part# PDP-17T
Edelbrock 383 Torker single plane intake manifold
Fel Pro complete engine gasket set
Extra set of head gaskets from 440source, the ones I ordered with the heads
ARP Head bolts
440source forged 4.15" stroke crank
Eagle H-beam 440 rods, full floating pins with ARP Bolts
440source stroker windage tray
440source chrome neytral balance fluid damper
Pro Comp 1.5:1 roller rockers (used)
Brass freeze plugs (installed)
Chrome moly rocker shaft
440source rocker shaft hold down kit
440source sheetmetal valley pan
billet aluminum valley pan hold down bars
Mallory Unilite distributor (used)
New intermediate drive gear bushing
Billet Aluminum fuel pump block off plate
440source Bronze Gear Intermediate shaft part# 200-1085
Polished stainless steel shorty headers
I also have a stock 727 trans to go with it
I know I missed a couple things, but this is just about everything I have for the big block