Just Installed my New Compressor Today

I figured that the tank on the Husky was still fine so I'm using as an additional resevoir. With the new comp at 60 gallons and the Husky at 32 I now have 92 gallons of air at my disposal.

I put a little thought into this. The connector from the 3/4" pipe T is an automotive style 3/8" high capacity style female connector to the same male connector on the Husky. I have a ball valve on both compressors so I can just dissconect the Husky and roll it away charged with air or shut the valve off, disconnect it and use the big female connector if I need the additional flow to run a 3/4" impact. I'm hoping that will also help to cool the air and collect water and oil too.

The new CH compressor is bolted to the floor and is way quieter than the old Husky and fills both tanks faster than the Husky could do just one. Once most of the piping was done I ran the CH to about 60 psi and opened up the ball valve to blow the garbage out of the new pipes before I put the quick disconnect fittings on... It just about blew everything off of 20' of bench, lol.