Tig welding 101

i like the KEMPI TIG welder at my job im not the best welder out there and dont do it everyday but i do tig a couple times a week mostly exhaust stuff and as long as no one has reset the preprogramed chanels for wave and power i can make pretty good welds withit even if i dont do it everyday.
dont know how hard they are to get parts for in US but over here they are comon and wellknown as good welders
also i recomend you get one with a watercooler if you are going to put some time into welding with it i know how hot the non cooled part of the handle can get if i do alot of welding and i realy wouldnt want all that heat in the handle,may be good to talk to the salesman when you buy one about that feature:)

it takes some time learning but is kind of similar to welding with a torch:)
just have patience and give it some time and you will love it,it takes time but the result is good! i need alitle less than 5minutes to completly end to end weld two pieces of 304 stainles in 3" with a wallthicknes of 1,5mm togheter on an average day so it takes some time but the result is alot better compared to MIG