Torsion Bar clips won't install

Its crazy but I JUST RESOLVED "my" lower control arm issue TODAY.

I know what is going on.

(1) Pivot Shaft pressed TOO FAR into Bushing.
(2) Bushing Sleeve Probably sticking through to Torsion Bar seat

This happens because someone did not know the correct procedure for Lower Control Arm bushing installation.....Like me....I pressed the bushing into the arm FIRST, then pressed the Pivot shaft in.....it never would let me get the Torsion Bar in properly.

The way I got it all to work correctly was:

1. Press Out Pivot Shaft
2. Air Hammer out Rubber Portion of Bushing
3. Chisel a Groove down the inside of the bushing "case"...drive out with chisel/hammer
4. Die Grind Groove down bushing "sleeve" still on pivot shaft
5. Remove fuBar'd sleeve with chisel and hammer
6. Get NEW Bushing
7. Wire Wheel Pivot shaft
8. Press Pivot Shaft INTO Bushing
9. Press Bushing/Pivot Shaft into LCA.
10. Look into Torsion Bar Seat to Check to make sure your Pivot Shaft/Bushing Sleeve do to protrude into Torsion Bar Seat area.

Done.:cheers: