Starter and Z-bar Binding! pics

Well im done. I had to redrill the trans ball stud mount. the slotted hole on the bottom was slotted about one half inch. The top whole was re drilled 1/2 inch up and about 3/8 back. The z bar was cut to be 6 and 7/8 inches long. total of almost 3/4 of an inch taken off from it. The Reverse shift rod worked and the 1-2 shift rod hit the crossmember so it was adjusted slightly. The 3/4 gear was lenthened one inch but mostly retained factory bends. I hooked a heavy spring to the clutch fork and then back by the starter The shifter had very loose fit on the shift rods so my dad made bushings for them and that snugged them right up. install is done.