Anybody running 17" Cobra Bullit rims on a Duster

Well, I finally got around to getting my wheels on, thanks to this thread so I thought I'd post my setup:

Wheels: 05 bustang mullits :lol:

Tires:
Front - 245/40/17
Rear - 245/45/17

Spacers:
Rear - 2 inch
Front - 1.25 inch hub centric

Notes:
1. The 1.25" spacers on the front are hub centric and are short enough so the snout of the disk up still protrudes into the wheel.
2. 40 series tires were chosen for the front because the fender clearance at the rear is close and I wanted some extra breathing room.
3. Outer tie rod end is roughly 1/2 inch from wheel.
4. Spacers in the front allow the use of stock center caps ( modified to remove stock logo ). Basically just filled with 5 min epoxy, sanded and painted.
5. Rear tires are approximately 3/4 inch from leaf ( leaf in stock position )
6. Cost of the tires is only included for reference. I was within weeks of needing new tires for the wheels that were on the car so that expense would be there with or without new rims.

Personal cost
Wheels with lugs - $100
Spacers - free ( craigslist swap ) :)
tires - $180 ( deal on some discontinued rears and used fronts )
paint - $15

Total out of pocket to date - $295
and I'll be selling the wheels that were on it to recoup some of the cost.

.... and here is the result.