eddy performer probs and question

rigrunner said
used 600 ...........gas will come out of the tube beside the hole for the metering rods on the left side top of carb. would this be caused by the float level.

This almost certainly has to be a damaged needle/ seat, float, or float out of adjustment. Check also that the float does not go "too far down."(This is the "float drop" spec) I guess you know you can download the destructions from Edelbrock

rigrunner said
mildy cammed 318. last is there any way to make the secondaries come in sooner? thanks

I doubt very much that you WANT them to

Since this is used, I'd clean it all out, use carb cleaner aerosol to pressuries every port and passage you can find. WATCH your eyes.

Carefully check "the book" for jetting and setup. Because it's used, you really don't know what you have.