I need a recommendation please

crackedback said

I don't know what some of you guys are doing...

I used ONE blair rotabroach bit to take apart almost 3 cars, floorpans, inners, frame rails trunk pans, 1/4ers, tailpanels, the whole deal.

If the bit starts to walk, tilt the drill handle in the direction it's walking and tighten up the tension on your pilot.

Click to expand...

I have had the same good results with the Blair rotabroach, especially when you put a nice deep divot on the spot weld with a center punch to keep the bit from walking, use some cutting oil or WD40, and keep the drill speed low. I went through several bits when I was learning how to do it, but now that I take my time the bits last forever.

I loaned my bits to a buddy who didn't listen to my advice and he ruined them all really quick. #-o

Scott