Mounting Late model Buckets in my 68 Dart - issues

Well, as usual I decided to go the more difficult route...lol

I'm cutting out the floor humps and welding in flat metal in its place.
Have the passenger side almost done, haven't started on drivers side yet.

I did remove the brace underneath, and I replaced it with a new one that fits the new contour of the floor. So the seat is well supported on the outside. Both the front and rear bolts go right through the supports that are underneath.
I will add some reinforcing plates made of 16ga under the inner side seat rails.

This was more work I'm sure than the other way, but it will come out nice. The seats will be nice and solid, and wont we any higher than neccesary.

Also, a nice feature of these Scion seats is that the passenger seat not only leans forward to allow entry into the back seat, it leans forward and then slides forward.
Check out video, should be nice for people trying to get into the back !

[ame="http://www.youtube.com/watch?v=4rpVws8prWY"]YouTube - S5002586.AVI[/ame]