Ok so lets really talk K-members here Folks

70Duster that's the poisondart built by Schwartz chassis and the engine is a 572 hemi. What I see when I look at that picture is severe angle on the tie rods and a complete lack of Ackerman like everyone is so quick to point out is a must.

Joe, Tory has been street driving with this k-member and suspension for over a year and has been designing it for 3. He has shown his design to some of his peers and they all have commented on how well designed the system is. Even someone who has been mentioned in this thread a good deal has praised this system and commented that it was time he wasn't the only pony at this show.

I know this is relatively unknown and untested (without years of postings and articles) but you guys are very quick to say it's junk when you don't know that much about it. I will be getting a k-member from Tory in about a week/week and a half and after I mock up my motor mounts and send him measurements he asked me to try my best to destroy it. I have a spare factory K-member so I will do comparisons between the 2 side by side pictures and side by side destruction so you can see what this thing is made of.