Lower control arm bushing - Help please

Cutting out with a chisel is a beast, but if you don't weld, it is a way to go. If you have air tools, even better. I did one without air tools, took me about an hour to get it all out, and with the air tools, took about 15 minutes. Just have to be careful to not cut up the LCA too bad. Groove it on one side, cut the lip and then go to town.

If you gouge up the LCA, you can smooth it out with a Brake cylinder hone. Throw it on your drill and run it thru the hole until the area is free of burrs. A dremel tool with a deburring tool works good too.

I did it this way as I weld for crap and I sent the air compressor home with Gene :(