Help!! Power steering pump and bracket identification

You can put a seal kit in it.

-Pull the pulley off.
-Hold the cast iron body in a vise by the snout.
-Remove 3? bolts in the back and the high pressure port/bolt.
-Lightly tap the can off from the body.
-Make sure the surface where the o-ring rides on the can is smooth and no big pits.
-croucus cloth/clean up can to o-ring contact surface.
-You can remove dents in the can now.
-put new o-ring around body and square o-rings for pressure port/bolt
-Re-install can
-chisel out front seal.
-tap evenly in new front seal
-re-instally pulley