Trim Identification Needed

When I bought my car, I was under the impression that all the trim sitting in the back seat at the time was trim that was not currently installed on the car. Go figure when I tried to match stuff up very little of it seemed to fit right. At this point, it does me little good to hold on to the trim, but seeing as there is no identifying marks on it, I don't know what it's off of to try to sell it. That being said, can anyone help me try to figure out what these trim pieces are off of? The long two piece trim with the center cap looks an awful lot like the trunk of my car (a 67 Dart) and appears to match the contours of the trunk lid fairly well, but I can't find any pictures that specifically show this trim on the trunk lid. Can anyone confirm if that is what this piece is really for or if it's some kind of hood trim for a different body style? Another question I have regards the windshiled trim I have. When put next to my windshield, the A piller piece is about 1.5-2 inches too long (see in the picture below), so it's not for a 67 hardtop. Does anyone have A pillar measurements out there for the different body styles? I don't know if the trim is just some different A body piece (either different body style like a 2 door post or 4 door or just a different year thing), or off of an entirely different platform like a B or E body. The last question I have regards the rear window trim pieces (in the middle of the windshield trim in the pictures). My car has the upper L pieces installed, but when I put either of the lower pieces on, the contour just doesn't quite match up (see pictures below). Did the rear window shape change at all over the years or could this too be off of a different platform like a B or E body? I would greatly appreciate any help you all can provide. I'm looking to sell off all of my extra leftover stuff to help fund a 3g hemi swap :smile:.