Piece of **** Mallory Distributor

Here are basic mallory unilite installation instructions for optical alignment. Will PM you complete instructions.

Oldschoolcuda

UNILITE® DISTRIBUTOR INSTALLATION
Step 1
Remove the distributor cap from the UNILITE® Distributor.
Step 2
Place the UNILITE® Distributor in the engine. Rotate the UNILITE®
Distributor housing in the opposite direction of rotor rotation until the
nearest slot on the rotor’s shutter wheel is aligned with the optical eye
of the UNILITE® Module. This will generally give timing close enough for
starting purposes. Put the distributor hold down clamp in place and
tighten slightly, leaving it loose enough to turn the UNILITE® Distributor.
Make a mark on the UNILITE® Distributor housing where the rotor points.
Step 3
Install the UNILITE® Distributor cap. Remove the spark plug wire on the
original distributor cap that the engine timing is set from, and install it
onto the UNILITE® Distributor cap post above the mark on the UNILITE®
Distributor housing where the rotor had pointed. Install the remaining
spark plug wires from the original distributor cap to the UNILITE®
Distributor cap in the same sequence.