SBP disc brake conversion

'64 Cuda said

Thanks! That's the info I needed. One site just listed them as Set 6 & Set 2.


Well, crap! I thought that was all for the info I needed. I figured the bearings out. Now I look at wheel seals & they list 3 different ones. 9", 10", & 11" brakes. I know they never used 11" drums on these cars & the disc is almost 11" in diameter, just not quite. Is the seal for 11" brakes the one I need?

Click to expand...

Get the ones listed for the 11" brakes. They are very similar to the ones for 10" drums and may even work the same but the width is different:

10" Drum - Shaft Size=1.73", Housing Bore=2.336, Outer Diameter=2.34, Width=0.47in

11" Disc - Shaft Size=1.73", Housing Bore=2.336, Outer Diameter=2.34, Width=0.25in (This matched the size of the old ones I'm replacing in my KH SBP setup)

I got the ones for the 10" drum the first time, I haven't installed them yet so I'm going to swap them out for the disc variety. Even though the drums variety is wider I pieced them together and I think they'll work with discs anyhow.