Pushrod Angle problems

No lifter bores bushed. That is why I went with custom ground small base circle cam, to make the lifters ride lower in the lifter bores so lifter oil groove does not become exposed at max lift. The small base circle also helps with the angle because the lifters ride lower down. I used the Crane hydraulic roller lifters. The engine has been together for two years and its been run hard; my guess is around 1500 miles. Haven't even adjusted the valves yet and it runs like a champ. Valve train is completely quiet too.

Brian at IMM spec'ed out the cam and had it ground for me. Same cost as an off the shelf cam for the most part. He had to have a second cam ground because my block was so sloppy we needed a smaller base circle cam then any engine he had ever seen. No cost on the retry either.