Stock Rods the way they're ment to be!

No worries mate, the rods will be perfect even with the "wrong", and hey, if they're not I'll just run them through again and run other bearings. I don't mount anything that isn't within tolerances in my engine! Sure I could have bought new I-beams but these rods from total stock to this cost me grinding material and Arp bolts and nothing more so saving a bit of cash and the mopar rods hold up to my build with TONS left!

Simple fact regarding the bolts is that if you do a good job when you do it there really such a small difference between two bolts of the same brand that it most likely won't even show on the indicator clock when I measure the rod, and if it do it's well inside the tolerances. Just saying. Done it before and one of the engines I know that also did it has ran 340000kilometers by now without isues!

Duster340 - Thanks mate! Yeah it's quite alot better in the south already here in Luleå where I live most of the time it's alot better... only 27-C today! I was in Ohtanajärvi when I wrote and I think that's even above the circle ;)