WTB drive shaft

Thanks Marks340 but 45 1/2 inch is a little short. I'm going by the old Direct Connection chassis manual. I've always used their specs on my drag cars and had good luck. The manual says to have the weight of the car on the wheels then slide the slip yoke in the tranny leaving 1 inch before it bottoms out then measure between the front and rear yoke centers. I bought this car unfinished and the previous owner had the drive shaft cut to fit. I don't know why he had it made so short. The yoke is only in the trans about 1 inch. If I can find one longer than I need I can have it shortened but there is no way to make one longer that I know of.