Control arms

-
Status
Not open for further replies.
oldguy

oldguy

Well-Known Member
Joined
Jul 18, 2008
Messages
155
Reaction score
0
Location
Reno, Nevada
Rating - 0%
0   0   0
Contact seller
Does anyone know where I can get a set? So far, I've struck out. I was told they are all the same from 63 through 76. Can they be straightened? I'm thing that would be tough without heat and I don't want to use heat as that would probably weaken them. Thanks for any help. Mike Oops! Noticed I forgot to mention that I'm looking for the strut rods that go to the control arms and not the arms themselves. It's a ***** getting old!!! LOL
 
I have a few sets lying around. How bout $25.00 for a pair and you pay the shipping?? Let me know, Geof
 
You could probably straighten them out in a press without any issues.
I've seen it done before with no problems.
The only question i have is how did they get bent in the first place?
Carefully check out the whole frame and suspension to be sure nothing else is bent or cracked.
 
Thanks guys for all the offers! I'll try a press to get them straight first and then if that doesn't work will have to buy some. They look like the PO ran over some rocks and bent the strut rods up in a bow slightly. The alignment shop doesn't want to mess with the front end because of the bends. The rest of the suspension looks pretty straight. I'll keep the info handy and get back to everyone. Mike
 
Status
Not open for further replies.
-

Back
Top