Show me your frame connectors

OK, I'll jump in here.

I did my own subframe connectors. I tried to model them after the Hotchkis connectors, with a few changes.

I used 1-1/2" X 2-1/2" rectangular tubing, 1/8" wall thickness.

I'll let the pics speak for themselves, but basically I welded a flat plate to the front to weld to the crossmember, and another small plate underneath for more weld area at the front.

My connectors dont come through the floor, they fit tight up against the floor. I did make one small modification to the floor as you can see in one of the pics. I cut down the center of one of the "ribs" on the floor, then hammered it flat, welded it back together and covered it with seam sealer. This lets the connector sit higher up against the floor.

I beveled and capped the rear of the connector so it fits tight up against the front of the rear subframe.
I then cut plates out of 1/8" stock, that weld to the sides of the connector at the rear, and surround the rear subframe, these plates are welded to the sides of the rear-sub.
In these pics the connector still need another piece of 1/8" plate welded to the bottom of the rear section to finish it off.

Here are the pics in no peticular order.