quarter panel replace ment

green1 said

No offense, but what is their warranty?

Also, forgot to say, I cleaned the back, and welded in a 1" by 1/8" strap, for strength, and a burn-thru backer .

Click to expand...

good tip, decrease chances of over heating and warping,decrease chances of burning through and good for a bit of added strength.

1/8" isnt a must though, you could get away with a thinner gauge.

and if you do go that route be sure to take steps to avoid any rust collection in the area where the strip is at and use some weld through primer and some sealer when done.