FlowTech Headers

mmiruzzi · Mar 3, 2011

Any experiences with these headers in a '68 Barracuda.
Why are they half the price of identical specs. Hookers????

5258 · Mar 3, 2011

I have the ceramic coated flow techs on my 69 Dart small block, No issues with them, installed from the bottom up with the T bars out, did not have to raise the motor. So far no issues. The collector flange could have been thicker is my only complaint.

Mike..

SirDan · Mar 3, 2011

I bought them for my 73 dart. I haven't installed them yet but i do have pictures of the product.

MoparDart68 · Mar 4, 2011

Look just like the hedman headers I had. They hung too low and developed lots of dings on the drivers side.

Dartnut · Mar 10, 2011

If you have power steering, be prepared to modify the tube that hits the coupler.
I smashed mine almost flat there and have to take them out and modify the tube.
Manual steering should be o.k.
They do hang a little low.
I had to ding the tubes where they hit the torsion bars, but nothing serious.
All of this is in a '69 Valiant 2 door post with a 318 auto. Stock '69 k member and motor mounts.

stokey04964 · Mar 31, 2011

Does the T-Bar go through the header?

duster340 · Mar 31, 2011

used to have a set,fit good on my car with powersteering,alitle lowhanging but ok

rumblefish360 · Apr 1, 2011

stokey04964 said:
Does the T-Bar go through the header?

No, it does not, BUT, the steering linkage does.

rnaz · Apr 12, 2011

I just picked up a set of ceramic coated Flowtech's off of e-bay for $180 for my '70 Dart.

I'm glad to know that they won't be too much of a problem to install. (Especially since the motor will be out of it this weekend!)

FlowTech Headers

mmiruzzi

'68 Cuda Mule Car Replica

5258

Well-Known Member

SirDan

Well-Known Member

MoparDart68

Well-Known Member

Dartnut

Don't hate me because i'm beautiful

stokey04964

Well-Known Member

duster340

street racer

rumblefish360

I have escaped the EVIL Empire State!

rnaz

nitrous fed 390