Procomp rockers???

I just threw a new set in the trash, couldn't give them away, they where the aluminum needle bearing ones, looked terrible. wouldn't fit around a basic comp cam spring

I ordered the stainless set from kmj and the shims and hardware was scattered all over the bottom of the box and they were covered in grease/engine grime (not packing oil), obviously returned. the rockers were on the shafts and I know for a fact that don't come like that in the box. I tried to slide one off and it wouldn't come off the tip of the shaft, thats why they were returned i guess. I did mock them up on some heads and they all lined up perfectly, i must say they looked really nice, but I returned them. I have a feeling they punch the bolt and oil holes in the shaft and not drill them, this warps it out of round. the adjuster is a cup style so you can re use your pushrods. they are an exact copy of the pro mags but the roller tip doesnt look perfect, but, i would use them if they slid on the rocker shaft freely, although they did pivot in place just fine.