Accel ignition question!

I really don't know how else to 'xplain.

Your original blue coming from the ign switch through the bulkhead goes to one side of the ballast. This is hot in "run."

The OTHER side of the ballast goes to coil positive.

ALSO going to the coil positive is your original brown, coming from the ign switch, through the bulkhead, to the coil positive It is hot ONLY in START

Everything I described above IS NOT CHANGED from your original wiring.

All you should do is:

Add the red from the Accell to the coil positive, leave everything else that was original

Add the green wire to coil negative, in place of the distributor wire

Add the brown ground from the Accel box to ground.