Offset small block rocker arms

1wild&crazyguy said

So what did you use to tube the holes and how?

You can get 280's IME without going beyond the factory placed push rod hole wall, it will be about .030 thick though when you are done.

Do you have pics?
how much do they flow so far?

Click to expand...

I found the tube at home depot that you told me about, it is like .040 thick though, pushrod should fit if not I will trim the tube down, easier than I thought.

I don't have a flow bench, so I quite possibly could be hurting them, but I doubt it. When it is all said and done I will take them to get flowed, but this dude wants 20 dollars a hole, that sounds like b.s.

I can get you some pics tomorrow.