Does anyone make a small block engine cradle that's worth a @#!!

iv got our motor on a alum dolly i made .long block....front mts use alum angle..problem is rear mt...i wanted to work on clutch while it was sitting on this dolly..mopar didnt provide rear mts..if you bolt it to the bell, you cant dialin the bell to crank.to work on the rear of it clutch and pr plate.so i tryed the support holes [block to trans.[not very good..so to work on it i used a hoist from rafters to take a little weight off and support it..after putting it togerther, i made a starting frame of square tube stee and put in a k member used stock m/mnts built a ign system,used a pair of glass packs for mufflers,the radiater out of the car.portable boat motor gass tank for fuel..and lit her up...now iv got a starting rack i need to get rid of..while i get the steering finished and the harness rebuilt the motor sts and waits...anyone want to stop by and pick up this frame for starting your motor outside the car..j