After taking off window crank handle, arm rest etc...
Go to NAPA or the like. There is a tool (<$10.00) you slide in between panel and door and pry up, pull off. The tool is about 3" wide, flat with a fork in the middle ideal for going around the clip so it "lifts" from both sides at once relieving stress. When just pulling by hand you stand a chance of pulling panel and clip stays in door. That leaves a bigger hole in your panel to where the clip will no longer slide into the panel and hold because it was ripped out and not gently pryed upward and pulled out ward at same time.:read2:
I'm just sayin'8)
