Cylinder #1 no compression

dodgetkboy78 said

Dustin, I would assume the piston hit the valve to bend it, right?

Someone mentioned clay, now would be a great time to do that..... maybe pop some springs and make sure you don't have sticky guides too?

Click to expand...

I honestly am not sure what caused it to bend, because I would think that it would hit with more than just one valve if it was to the point of valves hitting.

I have already took all the remaining valve springs, and valves out that are on this head and inspected them for anything unusual or any resistance and they were all fine.

I will probably check clearances with clay tomorrow evening