Rod Bearings are Done :(

74Burntorange said
what do you mean both? How do you "clean" the block if it was hot tanked

all a hot tank is, is a box with a rotating table in it... there are jets on the top and bottom and it goes around for a while... gets alot but nothing inside if the oil galleys and all the other nooks and crannies...

1wild&crazyguy said
mr gasket sells brush kit for galleys.

soap and water, rough side of sponge on bores, checking cleanliness with paper towel, then wd-40 finish

I motor oil the bores just before installing pistons.

if it its gona sit for a while, use cosmoline.

wild is right on as normal!