Anybody run their exhaust through the roll pan?
The trouble with going through the pan is that there is an inner bracing full width that joins the rear of the chassis rails.
It could be done.Just a lot more work.
I've got MP offset spring hangers in mine which leaves little room between the fuel tank and springs for the tail pipes.Mine is set up so the tail pipes run straight and level under the chassis rails.
If yo cut a hole higher in the pan to exit them through the pan you would need some fancy bends at the end of the tailpipes.As I said,a lot more work.
Another shot of mine
The trouble with going through the pan is that there is an inner bracing full width that joins the rear of the chassis rails.
It could be done.Just a lot more work.
I've got MP offset spring hangers in mine which leaves little room between the fuel tank and springs for the tail pipes.Mine is set up so the tail pipes run straight and level under the chassis rails.
If yo cut a hole higher in the pan to exit them through the pan you would need some fancy bends at the end of the tailpipes.As I said,a lot more work.
Another shot of mine