Problem or run around?
All of you hit it right!! Murray's sells a oil feed line restriction plate. This is mounted just under the feed line on top of the cartrige. I did not buy one cause I had made the plate to start with.
Now in the kit has a plate with a hole as big as a paper clip to start with 1/16", then tells you to drill the hole open larger according to HP levels? I don't like it but it worked!!
What I did was weld the hole shut ground it off flat and drilled my hole starting with 1/16". No leaks with the hole at that size!! I will keep drilling the hole larger for more oil in turbo after moving the drain tube up per Prines request. The drain is over oil level now over 1" good point about whipping it passed the hole not allowing oil to exit smoothly.
[ame="http://www.youtube.com/watch?v=pZPPRhLMT2E"]YouTube - ‪twistedup‬‏[/ame]
Thanks to all I will get some more video soon. This is where boost just starts comming in 6#'s To fast for the zoom now? blurry:-|
See this oil line feed build here.
http://stormcomm.net/moparsnmorefor...D=f7a6ca1205f958f7910ab0726e6e3ef3&topic=93.0
All of you hit it right!! Murray's sells a oil feed line restriction plate. This is mounted just under the feed line on top of the cartrige. I did not buy one cause I had made the plate to start with.
Now in the kit has a plate with a hole as big as a paper clip to start with 1/16", then tells you to drill the hole open larger according to HP levels? I don't like it but it worked!!
What I did was weld the hole shut ground it off flat and drilled my hole starting with 1/16". No leaks with the hole at that size!! I will keep drilling the hole larger for more oil in turbo after moving the drain tube up per Prines request. The drain is over oil level now over 1" good point about whipping it passed the hole not allowing oil to exit smoothly.
[ame="http://www.youtube.com/watch?v=pZPPRhLMT2E"]YouTube - ‪twistedup‬‏[/ame]
Thanks to all I will get some more video soon. This is where boost just starts comming in 6#'s To fast for the zoom now? blurry:-|
See this oil line feed build here.
http://stormcomm.net/moparsnmorefor...D=f7a6ca1205f958f7910ab0726e6e3ef3&topic=93.0