**Twin Turbo 67 Dart Project**

I purchased a gang load of Heat Shrink, a new Solder Station and a new Heat Gun for the make up of the wiring harness.

I also need to buy one of these.....

http://www.acceleronics.com/versafueler.htm


View attachment Model4-complete_small.jpg


This goes in-between the MS3 and the Low Impedance Injectors. Supposedly with Sequential Fuel Injection and Low Impedance Injectors the Idle Quality with the 160lb Bosch Injectors ,"or ANY Bigger Low Impedance Injector",is way better. Either way with the MS3 you need to run some type of resistor set up when using Low Impedence Injectors.


View attachment Model3SequentialPage2.jpg