troubleshooting a horn circuit

67Dart 273,

thanks for the response. it is a 67 Barracuda...so the relay was in the bay mounted near the horns.

Looking back at the shop model, I may have missed a key step.

Manual says..place jumber between B and H terminals, If the horns operate the horn relay is faulty." Horns didn't go off, but I didn't press the horn ring at the same time. Not sure if that would make a difference.

Went ahead and pulled the horn contact out of the wheel. Assembly is held together with three rivets...but looks like the only metal to metal contact is at the edges of the two disks...If that is correct, then some light sandpaper around the edges should clean that up.

Two other possible issues, black ground wire in the wheel is pretty smashed and one of the three rubber detents on the horn switch is badly bent will post some pics once I find the flash card.

Thanks again...this site and the folks on it are absolutely great. Only wish I could add value too...but my skill level is slim to none so I'm often reluctant to chime in.