gear and pinion set up 8 3/4 489 case
You will need some dedicated tools to do the job right.
Do you have:
- A way to check pinion depth?
- Access to a press or a checking bearing?
- Dial indicator?
- Spanner wrench for the side adjusters?
- Torque wrench that goes over 200 ft lbs?
- Yoke holding tool?
- Seal and race drivers?
- Marking compound?
If so, go for it, it really isn't that bad!
Don't forget an extra crush sleeve for when you over tighten the pinion nut... doh! And a shim pack. And a bearing kit.