I need a Termoquad kickdown linkage

As far as adjusting the throttle pressure linkage, go under the car and move the pressure linkage forward and zip tie it or wire it there to hold it forward. Go up top and adjust your rod so it will slide over the pin with about a 16th of an inch play between the pin and the rear of the slot. Your linkage looks to be threaded so you can adjust it accordingly. Make sure the throttle on the carb is at rest on the idle circuit. Now that you have it on there and adjusted accordingly take it for a spin, you may need to do some fine tuning on the rod to get your shift points where you want them, very simple to do with the threaded rod.


DON'T FORGET TO REMOVE THE ZIP TIE OR WIRE YOU USED TO HOLD THE LINKAGE FORWARD.

Hope this helps.