My New Shop!! Yiippeee!

The brick mason showed up this morning to set up for a good start tomorrow.

On my part I haven't worked much on the shop because its been too dang hot to get anything done! I have pulled some wire to the light boxes on each side of the garage door and one beside the entrance door. I also bought and installed the entrance door as well and stubbed out a water spigot on the back. I had to special order a 21 ft brick lentil to go across the garage door. They delivered it today. Im going to wait until the brick mason gets his scaffolding up before I mount it to the laminated beam over the door. I don't believe its going to be the lightest thing in the world to get up there. Other than the brick lentil the brick mason can go to work without me being in the way.

The entrance door is a fiber glass type door and is better than the steel type doors. The steel type doors are bad about getting dents in them. I've been on job sites where the steel doors have dents in them before they are even installed! The fiber glass type is more expensive but supposed to be more energy efficient.

The ELK/GAF architectural shingles are on the job ready to be installed but the roofer (me) is not quite ready to tackle the job. lol
I'm going to borrow a roofing gun to hook to my air compressor but have not made it up to my friends house to borrow it. I believe that will make the job a little easier.

I've been looking at floor coverings and pretty much found a nice product that I can do myself. Its called Rock Solid. I really like the "Full chip" look.

https://www.rocksolidfloors.com/

Here is how its applied:

[ame="http://www.youtube.com/watch?v=qq-mCNRkbZo&feature=player_embedded"]Sam Memmolo's Garage Build Out featuring RockSolid Floors - YouTube[/ame]