Electronic Ignition Conversion HELP
I'm finishing up the 72 Dart Swinger 318 and it won't turn over. I got a Electronic Ignition system from a 76 Volare at a junkyard which included everything. This is how I wired everything:
Orange - to magnetic pick up distributor
Grey w/ Black stripe - to magnetic pickup distributor
Green - cut
Black w/ yellow stripe - to coil negative
Here's where I think I went wrong.
Light Blue w/ yellow - spliced into the dark blue that goes from ignition to the ballast resistor
the other ignition ecu with the three wires coming out is wired as:
white - grounded
green - alternator
dark blue - same ballast resistor terminal as the Light Blue w/ yellow goes to.
Now on the other side of the ballast resistor I have 2 Brown wires 1 of which go to the positive side of the terminal with the other going back into the harness somewhere. On the diagram it shows that I provide the wire to the coil positive but the wire looks stock. The diagram also shows that the yellow wire on the starter relay goes to the ballast resistor but the yellow wire off of my starter relay goes back into one of the large firewall plugs.
Everything was soldered so the connection is good but I think I have may have crossed a wire somewhere. ANy help would be greatly appreciaited and the sooner I get this doen the sooner I start it up!
here's the diagram I'm using:
I'm finishing up the 72 Dart Swinger 318 and it won't turn over. I got a Electronic Ignition system from a 76 Volare at a junkyard which included everything. This is how I wired everything:
Orange - to magnetic pick up distributor
Grey w/ Black stripe - to magnetic pickup distributor
Green - cut
Black w/ yellow stripe - to coil negative
Here's where I think I went wrong.
Light Blue w/ yellow - spliced into the dark blue that goes from ignition to the ballast resistor
the other ignition ecu with the three wires coming out is wired as:
white - grounded
green - alternator
dark blue - same ballast resistor terminal as the Light Blue w/ yellow goes to.
Now on the other side of the ballast resistor I have 2 Brown wires 1 of which go to the positive side of the terminal with the other going back into the harness somewhere. On the diagram it shows that I provide the wire to the coil positive but the wire looks stock. The diagram also shows that the yellow wire on the starter relay goes to the ballast resistor but the yellow wire off of my starter relay goes back into one of the large firewall plugs.
Everything was soldered so the connection is good but I think I have may have crossed a wire somewhere. ANy help would be greatly appreciaited and the sooner I get this doen the sooner I start it up!
here's the diagram I'm using:
