those that have builded a frontend?????

hemidanny this car will be full drag race ...the motor is going to be big block with chasiss pan and i hope some custom bob and mike headers(lol) trans is going to be for now 727 and rear gear is unknown right now ,tire will be pretty nice size slick any where from 10 wide to 13 but in the 29/30 tall i think ..
like i said i have done alot of reading and looking and research and all of it comes down to check your bump steer before you start and work from there if it is acc...now my car has had a good race type align. down to it and drove very well with the new control arm bushings and stuff at race speed and on the highway was fine...so i should be good to go on the bump steer i have , or just shoot to be better....from my understanding i should just tack the rack in and start with checking and if its not where it should be or where i need it to be move the rack up,down,in, or out to get it where it was...ackerman you turn the wheels and pulls strings and take measurements on both side and shoot for the same on that once you have your measurements in know its not that simple but thats the idea behind it from what i am getting...am i close or shooting in the wind????8-)