Auxiliary transmission cooler

I will be cutting two 1/2" holes side by side next to each other in the radiator support...Then installing a rubber grommet for a 3/8 line to pass through.... I have to bend and flare my own aluminum hard line...


I'm using a mix of aluminum hard line (3/8") and XRP -AN fittings along with their XR-31 nylon braided hose (- 6)...And in order to join the two together you need to use a 37* single flare for the hard line for use with a tube nut and sleeve...

There is a reducer available that goes from 1/2" pipe thread to -6 line.

Again, I'm using pretty expensive equipment for a rather simple setup and -AN stuff isn't really necessary...very costly...lol