Emblems & Decal placement for 72 340 Duster

There's a "Duster" name plate that goes on the front fender right where 95TeeTee's is, and where the holes are on yours. Some say there's a third name plate that goes on the tail panel. According to the parts manual, not so. There's also a gold foil covered Pentastar that goes on the lower portion of the passenger side fender, too.

There is a single "Plymouth" name plate that goes on the right rear edge of the decklid (as viewed from the rear of the car). The plate is roughly centered on the right rear tail light assembly.

There is also a single "Plymouth" name plate that goes on the right front edge of the hood (as viewed from the front of the car).

The "Plymouth" name plates are adhesive backed. I've seen carpet tape trimmed to fit and moulding tape trimmed up to locate these items. (I've also seen RTV sealant and epoxy used. Wouldn't recommend them.)

IIRC, if one of the body side stripe kits was on the car, the name plates were replaced with decals. Hope this helps.