Hughesy's 1973 Valiant Charger - New Hemi 5.7 swap
I had a look @ Daty's install and I don't see where he mentioned any problem with the mounts/insulators and they look unmodified.
I had another look on TTI's website and they mention to use 'FACTORY RUBBER INSULATORS' modification is required to the DRIVERS side insulator, however looking at the pictures they provide the drivers side looks unaltered other then the addition of a couple of spacer plates. The passenger side however looks modified to me, it looks as though the top of the rubber insulator has been cut at about 45 degrees to allow it to be installed that way and not make contact with where the oil filter block off plate goes.
Driver side
Passenger side
Can anyone confirm that you need to cut the rubber insulator??????
I had another look on TTI's website and they mention to use 'FACTORY RUBBER INSULATORS' modification is required to the DRIVERS side insulator, however looking at the pictures they provide the drivers side looks unaltered other then the addition of a couple of spacer plates. The passenger side however looks modified to me, it looks as though the top of the rubber insulator has been cut at about 45 degrees to allow it to be installed that way and not make contact with where the oil filter block off plate goes.
Driver side
Passenger side
Can anyone confirm that you need to cut the rubber insulator??????