What RPM Will a stroker Crank hold?

Well this all sounds pretty close to my stroker build.I,m not sure if it matters how much you spent on good parts,the right parts,well known parts.It only takes 1 second for catistrophic failure.On saturday I went to the track and on my first pass,I hit second gear and Kapoot!!Thats right,my H-beam Eagle stroker kit came out the pan and block.Now there was no early notice,no noise...nothing.It just happened in the blink of an eye.This is after 192 passes in the 1/4 mile at W.O.T.I will report my findings once I pull it and disassemble.I,m sure glad its the end of race season.:wack:
View attachment 273117

View attachment 273118
I don,t think it was the blocks fault,definetly a spun bearing.I have H-beam rods and ALL solid roller topend.Upon disassemble,first thing to see is my bend Manley pushrods,pulled the intake and down in the cam area I noticed what looks to be a wrist pin?:vom:Can,t really tell until I pull the engine and remove the pan.Hopefully I can salvage most of it for the next build:tard:
View attachment 66 Dart project Nov2010 376.jpg

View attachment 66 Dart project Nov2010 380.jpg

View attachment 66 Dart project Nov2010 379.jpg

View attachment 66 Dart project Nov2010 377.jpg