Advice, please! (Wiper Linkage Bushing Removal)

Removing them is a snap - they just pop out with a small amount of coaxing. You may find the new ones you need at NAPA. Soak the new ones in VERY hot water a few minutes to soften them, then use channel lock pliers - put a short socket over the hole on the back side so when you clamp down on the pliers the new bushing pops through. Before you snap the linkage back together, put a dab of white lithium grease in each bushing socket.

That's all the tips I can give you...other than, be sure to take pictures or make a sketch before you disassemble everything - it only goes back together one way.

Jerry

p.s. - I knew I posted these tips before... try this link: Wiper Linkage Bushings