Trans pan has a pin hole in it.

TrailBeast said
Do you not have a welding torch?
You know, the oxy acetylene set?
If you or someone close has a set, just braze it on the inside of the pan and done deal.
I sometimes use a good flux and propane torch with silver solder on steel and it works really well.
Just sucks to do it temporary, and then do it all over again.

I don't have a torch of any kind :coffee2: I did a real good job prepping and cleaning it with brake parts cleaner and then sanded the 2 sides with 220 grit paper then shot it down with brake / parts cleaner and did my patch, I have a few feelers out there for a good one, but for know I will put this one back on so I can winterize my RC now that I replaced the radiator :cheers:, It's an easy change and not a heavy job to do this again, 4 quarts on trans fluid this time and I will save the fluid for the next pan, I am going to change the filter, it has about 600 miles on a total rebuild :coffee2:
On my way out to get this dun :cheers: It's just 14 bolts and plenty of room under my RC. here I go , I called the dealer ship and they said $53 for a new one. I let the J.B weld set for 20 hours :colors: